This model comes as several files. Tap one to preview it, and tick the part(s) you’d like us to print.
Gothic Castle of Shadows
Printed for you, made to order
Colour · printed in PLA
No preference selected, we’ll choose a colour that suits.
About this model
<h4><strong>Electronics are optional - you can print and use the castle as a decorative model without adding any LEDs or electronics!</strong></h4><h4></h4><h5><strong>Recommended Print Settings: </strong></h5><p>Nozzle: 0.4mm (if you can use 0.2mm or 0.25mm - use it).</p><p>Support: Tree support required.</p><p>Bed adhesion: Raft for main tower.</p><p></p><h5><strong>List of Component:</strong></h5><ol><li><p>1x Red LED.</p></li><li><p>1x Green LED.</p></li><li><p>5x Yellow/orange LED.</p></li><li><p>7x Resistor (200-1000Ω).</p></li><li><p>1x Arduino Uno (with cable).</p></li><li><p>Wires.</p></li><li><p>Baking paper/paper.</p></li><li><p>Heat-shrinks/tape.</p></li></ol><p></p><h5><strong>List of Tools:</strong></h5><ol><li><p>Soldering iron (not necessary, but very helpful).</p></li><li><p>Hot glue gun.</p></li><li><p>Scissors (a hobby knife can work as well).</p></li></ol><p></p><h5><strong>Instructions:</strong></h5><ol><li><p>Print all 3 model files and carefully remove the supports.</p></li><li><p>Insert the castle and main tower into the rocks. Be careful not to break any part of the model.</p></li><li><p>Solder a resistor to the positive (longer) leg of each LED.</p></li><li><p>Solder a wire to the resistor (the wire should be around 25-30cm long).</p></li><li><p>Solder a wire to the negative (shorter) leg of each LED (the wire should be around 25-30 cm long).</p></li><li><p>Use the heat-shrinks/tape to wrap each leg of the LED and the resistor. Make sure that…
Description by the designer on Printables.
How it works
- You pick the model; we fetch the designer’s file and print it in our UK workshop.
- Every piece is hand-finished and quality-checked before it ships, like everything in our shop.
- Printed in PLA, a plant-based material. More about our material.
This design was created and shared by an independent designer and remains their property. Every model offered for printing here has a licence that permits commercial printing. The original model page and licence are linked above.
